P0341 fault code: what it means

P0341: Camshaft position sensor signal is out of range or does not line up with the crank signal.

Engine and gearbox (powertrain) · Costly if missed

Usual causes, most likely first

stretched or jumped timing chain / belt
failing camshaft position sensor
faulty VVT solenoid or phaser
damaged sensor wiring

P0341 by make

Audi

Camshaft position sensor signal does not make sense to the engine computer. On 2.0 TSI chain engines, check timing before replacing the sensor.

Usual causes: incorrect cam timing (stretched chain or worn tensioner); faulty camshaft position sensor (G40); damaged sensor wiring or plug; low oil level or pressure

Honda

Cam and crank signals do not line up as expected. On Honda K24 and 1.5 turbo engines this usually points to a mechanical timing issue, often with a cold-start rattle from the VTC actuator.

Usual causes: faulty VTC actuator (cold-start rattle); stretched timing chain or worn tensioner; camshaft position sensor

Isuzu

Camshaft position sensor performance.

Usual causes: faulty cam sensor; sensor wiring interference; timing problem

Skoda

Camshaft position sensor signal does not make sense to the engine computer. On 2.0 TSI chain engines, check timing before replacing the sensor.

Usual causes: incorrect cam timing (stretched chain or worn tensioner); faulty camshaft position sensor (G40); damaged sensor wiring or plug; low oil level or pressure

Volkswagen

Camshaft position sensor signal does not make sense to the engine computer. On 2.0 TSI chain engines, check timing before replacing the sensor.

Usual causes: incorrect cam timing (stretched chain or worn tensioner); faulty camshaft position sensor (G40); damaged sensor wiring or plug; low oil level or pressure

What the repair usually costs

Crankshaft or camshaft position sensor replaceNZ$100–NZ$590 · A$100–A$580
Timing chain, tensioner and guides (4-cylinder)NZ$1,120–NZ$2,530 · A$1,160–A$2,570
Timing chains and tensioners (V6 / V8)NZ$1,890–NZ$4,080 · A$1,920–A$4,110
Glow plugs (diesel, set of 4)NZ$250–NZ$850 · A$250–A$850

Not sure what P0341 means on your car? Ask Credov.

Before you clear it

Write the code down or photograph the scanner first. A code that comes straight back after clearing points to a fault that is still there. A car whose codes were cleared just before you arrived may be hiding one: the scanner's readiness monitors show "not ready" for a while after codes are cleared.

Researched by Credov from manufacturer and workshop sources. A fault code points to where a fault may be; a workshop confirms it with a diagnosis. Browse all fault codes.